[jboss-jira] [JBoss JIRA] Commented: (GPD-169) GPD Diagram node and text positioning not saving.

[David Roberts (JIRA)]

    [ http://jira.jboss.com/jira/browse/GPD-169?page=comments#action_12380379 ] 
            
David Roberts commented on GPD-169:
-----------------------------------

I said above that "Each time I open my process definition", the nodes are re-ordered. My mistake, it's not each time for the nodes, it's each time for the text positioning. The node positioning problem is intermittent, and has only happened a few times. However, the text position is every time I re-open.

> GPD Diagram node and text positioning not saving.
> -------------------------------------------------
>
>                 Key: GPD-169
>                 URL: http://jira.jboss.com/jira/browse/GPD-169
>             Project: JBoss jBPM GPD
>          Issue Type: Bug
>    Affects Versions: jBPM JPDL Designer 3.1.0.GA
>         Environment: Eclipse 3.3, EMF: 2.3.1, GEF: 3.3.1, DTP: 1.5, WTP: 2.0, jbpm-jpdl-designer-3.1.0.sp1
>            Reporter: David Roberts
>         Assigned To: Koen Aers
>         Attachments: Before and After.jpg
>
>
> Upgrading to jbpm-jpdl-designer-3.1.0.sp1 gives me the following problem:
> When re-opening a process definition with the GPD, my nodes are jumbled up and placed at random locations. So there is this web of transition lines running everywhere to reach the nodes. You can't see what's going on. Each time I open my process definition in the GPD to work with it, I have to spend 10 to 15 minutes re-aligning everything.
> Transition text also has a problem:
> All my custom aligned/positioned text on all my transitions get reset when re-opening the process in the designer. They stick to the transition line, and if the transition line is quite short, the text then overlaps my nodes etc. It looks terrible. 
> I tried re-positioning all the text again, and saving, but as soon as I close and re-open my process again, the text is snapped back onto the transition lines, and it looks terrible again. 

-- 
This message is automatically generated by JIRA.
-
If you think it was sent incorrectly contact one of the administrators: http://jira.jboss.com/jira/secure/Administrators.jspa
-
For more information on JIRA, see: http://www.atlassian.com/software/jira