[ https://issues.jboss.org/browse/FORGE-2291?page=com.atlassian.jira.plugin... ] George Gastaldi updated FORGE-2291: ----------------------------------- Description: I have some Camel forge commands, and we have completers for some options. One of the options is to provide a Camel component name. And as we have a lot of then, eg 180 then the completer asks if you want to show them all or not. If you type N then the CLI exits, and you have to redo the command again. I would expected N to go back so I can continue typing on the current command as if I didnt press TAB to trigger the completer. See below for example {code} [foo]$ camel-add-endpoint-xml --componentNameFilter --componentName --instanceName --xml [foo]$ camel-add-endpoint-xml --componentName Display all 180 possibilities? (y or n) [foo]$ {code} If I hit ESC instead I would expect it to exit which it does. So typing N should take me back, so I can continue typing that command as-is. was: I have some Camel forge commands, and we have completers for some options. One of the options is to provide a Camel component name. And as we have a lot of then, eg 180 then the completer asks if you want to show them all or not. If you type N then the CLI exists, and you have to redo the command again. I would expected N to go back so I can continue typing on the current command as if I didnt press TAB to trigger the completer. See below for example {code} [foo]$ camel-add-endpoint-xml --componentNameFilter --componentName --instanceName --xml [foo]$ camel-add-endpoint-xml --componentName Display all 180 possibilities? (y or n) [foo]$ {code} If I hit ESC instead I would expect it to exit which it does. So typing N should take me back, so I can continue typing that command as-is. -- This message was sent by Atlassian JIRA (v6.3.11#6341)