On 21/12/2010, at 7:35 PM, Dan Allen wrote:
seam-parent 5 and seam-bom 3.0.0.b04 are now ready.
I also updated config and persistence to use all the new dependency management goodness. All tests pass, as far as I can tell.
I've noticed that we are going to have to address an issue with the migration from Weld 1.1.0.Beta1 to CR1...it's not a drop in replacement. Neither the config nor persistence tests will pass on CR1. We need to dig deeper. I will give you a hint though...the order of the type parameters on ProcessProducer and ProcessProducerMethod has inverted. You can see this in the Solder LoggerExtension test. So we'll cross that bridge in time.
I think that this is an issue with Arquillian not being compatible with 1.0.0.CR1.
For now, release away!
On Tue, Dec 21, 2010 at 1:01 AM, Dan Allen <firstname.lastname@example.org>
On Mon, Dec 20, 2010 at 11:42 PM, Stuart Douglas <email@example.com>
Both my modules have been switched over to solder. Hopefully I will release tonight.
Thanks Stuart. Actually, if you hold off, I'm going to switch your modules over to a new parent, thus aligning some of the dependencies. I'll send you an update when I'm done. Working now.
Principal Software Engineer, Red Hat | Author of Seam in Action
Registered Linux User #231597http://mojavelinux.com