[jboss-jira] [JBoss JIRA] Updated: (JGRP-129) Logical addresses

[Bela Ban (JIRA)]

     [ http://jira.jboss.com/jira/browse/JGRP-129?page=all ]

Bela Ban updated JGRP-129:
--------------------------

    Fix Version/s: 2.8
                       (was: 2.x)

> Logical addresses
> -----------------
>
>                 Key: JGRP-129
>                 URL: http://jira.jboss.com/jira/browse/JGRP-129
>             Project: JGroups
>          Issue Type: Feature Request
>    Affects Versions: 2.2.9
>            Reporter: Bela Ban
>         Assigned To: Bela Ban
>             Fix For: 2.8
>
>
> The address chosen by each node is essentially the IP address and port of the receiver socket. However, for the following reasons, this is not good enough:
> - The node is shunned (excluded) and re-joins after leaving. We'd like to have the same logical address, although the physical address changed. This is already done in JBoss code, should be available in JGroups proper
> - NIC failover: a NIC goes down, we want to continue sending/receiving on a different NIC
> - The sender sends on all available NICs (send_on_all_interfaces="true"). This means that -if we take the receiver's datagram packet's address to be the identity of the sender - we get N different identities; 1 for each interface the message is sent on
> - Network Address Translation: the sender's address might get changed by the NAT
> DESIGN: 
> - A logical address is picked, either by JGroups, or set by a user on channel creation. The lifetime of this address is the lifetime of the process in which the channel is created, or until channel.close() or disconnect() is called.
> - Each member as a small cache, in which it associates the logical addresses for messages received with the sender's address. When a message is to be sent to a logical address (unicast message), the corresponding physical address is looked up from the cache. Note that there maybe multiple physical addresses if the same message was sent on different interfaces (send_on_all_interfaces="true").
> - The logical addresses must be picked such that they cannot be reused after disconnect()/close().

-- 
This message is automatically generated by JIRA.
-
If you think it was sent incorrectly contact one of the administrators: http://jira.jboss.com/jira/secure/Administrators.jspa
-
For more information on JIRA, see: http://www.atlassian.com/software/jira