[jboss-jira] [JBoss JIRA] (DROOLS-3187) [DMN Designer] Add support for bend-points on connectors

[Jozef Marko (Jira)]

     [ https://issues.jboss.org/browse/DROOLS-3187?page=com.atlassian.jira.plugin.system.issuetabpanels:all-tabpanel ]

Jozef Marko updated DROOLS-3187:
--------------------------------
    Description: 
DMN1.1 did not contain layout information.

DMN1.2 contains layout information and supports "bend points" in connectors.

Bend-points are supported in Stunner so should be reasonably simple to add to DMN UI.

h2. Manual acceptance test
- Save and reopen diagram where multiple bendpoints used
- Save and reopen diagram where bendpoints were removed
- Try to open externally diagram with bendpoints
- Try to deploy diagram with bendpoints on kie-server

  was:
DMN1.1 did not contain layout information.

DMN1.2 contains layout information and supports "bend points" in connectors.

Bend-points are supported in Stunner so should be reasonably simple to add to DMN UI.



> [DMN Designer] Add support for bend-points on connectors
> --------------------------------------------------------
>
>                 Key: DROOLS-3187
>                 URL: https://issues.jboss.org/browse/DROOLS-3187
>             Project: Drools
>          Issue Type: Enhancement
>          Components: DMN Editor
>            Reporter: Michael Anstis
>            Assignee: Michael Anstis
>            Priority: Major
>
> DMN1.1 did not contain layout information.
> DMN1.2 contains layout information and supports "bend points" in connectors.
> Bend-points are supported in Stunner so should be reasonably simple to add to DMN UI.
> h2. Manual acceptance test
> - Save and reopen diagram where multiple bendpoints used
> - Save and reopen diagram where bendpoints were removed
> - Try to open externally diagram with bendpoints
> - Try to deploy diagram with bendpoints on kie-server



--
This message was sent by Atlassian Jira
(v7.12.1#712002)