ReplyTo EPR must be manually reset after Aggregator action is used ------------------------------------------------------------------ Key: JBESB-3311 URL: https://jira.jboss.org/jira/browse/JBESB-3311 Project: JBoss ESB Issue Type: Bug Security Level: Public (Everyone can see) Components: Content Based Routing Affects Versions: 4.8 Reporter: David van Balen Fix For: 4.9 The ESB depends on the message's replyTo to know where to send a reply in a RequestResponse service. However, the Aggregator action makes no attempt to preserve the replyTo when it creates an aggregate message for a series. In most cases, I would think the replyTo on the aggregated messages would be the same, so adding it onto the resulting aggregated message would seem like a good idea. Otherwise, it has to be handled manually in the assembler action. -- This message is automatically generated by JIRA. - If you think it was sent incorrectly contact one of the administrators: https://jira.jboss.org/jira/secure/Administrators.jspa - For more information on JIRA, see: http://www.atlassian.com/software/jira