10 p.m.
This fails for me. Can't figure out why. It passes if I just go into
testsuite/integration and run mvn clean install, doesn't pass on a full
build. I get BindAddress failures in startup. Not sure how this test
is different than others other than it being the very last test that is run.
--
Bill Burke
JBoss, a division of Red Hat
http://bill.burkecentral.com
8:59 a.m.
Works fine here and on Travis. Maybe something Windows specific? Bind
address failure sounds like it's actually the previous test that's not
cleaning up properly rather than ClientInitialAccessTest actually failing.
Maybe try to put an @Ignore on the test that runs before and see if it
works then?
On 21 December 2015 at 22:00, Bill Burke <bburke(a)redhat.com> wrote:
This fails for me. Can't figure out why. It passes if I just go
into
testsuite/integration and run mvn clean install, doesn't pass on a full
build. I get BindAddress failures in startup. Not sure how this test
is different than others other than it being the very last test that is
run.
--
Bill Burke
JBoss, a division of Red Hat
http://bill.burkecentral.com
_______________________________________________
keycloak-dev mailing list
keycloak-dev(a)lists.jboss.org
https://lists.jboss.org/mailman/listinfo/keycloak-dev
3041
days inactive
3042
days old
1 comments
2 participants
participants (2)
-
Bill Burke -
Stian Thorgersen