[ https://jira.jboss.org/jira/browse/GPD-390?page=com.atlassian.jira.plugin... ] Markus Kopka updated GPD-390: ----------------------------- Environment: Eclipse 3.4, jbpm-jpdl-designer-3.1.4 (was: Eclipse 3.3, EMF: 2.3.1, GEF: 3.3.1, DTP: 1.5, WTP: 2.0, jbpm-jpdl-designer-3.1.0.sp1) Affects Version/s: jBPM jPDL Designer 3.1.7 Description: Using jbpm-jpdl-designer-3.1.4 gives me the following problem: Sometimes when re-opening a process definition with the GPD, my nodes are jumbled up and placed at random locations. So there is this web of transition lines running everywhere to reach the nodes. You can't see what's going on. Sometimes I open my process definition in the GPD to work with it, I have to re-aligning everything. This does not affect any configuration of nodes or the classes. But it becomes impossible to understand the process flow from the diagram was: Upgrading to jbpm-jpdl-designer-3.1.0.sp1 gives me the following problem: When re-opening a process definition with the GPD, my nodes are jumbled up and placed at random locations. So there is this web of transition lines running everywhere to reach the nodes. You can't see what's going on. Each time I open my process definition in the GPD to work with it, I have to spend 10 to 15 minutes re-aligning everything. Transition text also has a problem: All my custom aligned/positioned text on all my transitions get reset when re-opening the process in the designer. They stick to the transition line, and if the transition line is quite short, the text then overlaps my nodes etc. It looks terrible. I tried re-positioning all the text again, and saving, but as soon as I close and re-open my process again, the text is snapped back onto the transition lines, and it looks terrible again. -- This message is automatically generated by JIRA. - If you think it was sent incorrectly contact one of the administrators: https://jira.jboss.org/jira/secure/Administrators.jspa - For more information on JIRA, see: http://www.atlassian.com/software/jira