I am getting a large amount of warnings ( > 1000) on Seam components. On every save, build, etc., the Seam validator chisels away at these warnings. You can watch the number of warnings decrease over time. Once this number of warnings is reduced to, say, 200...the number goes right back up to 1000+. The next time Seam validator runs, which seems to be at all times, it again chisels away against these warnings only to repeat the above process. Is there something I have done wrong with the configuration of the project? Anyone else experiencing this problem? Thanks. View the original post : http://www.jboss.com/index.html?module=bb&op=viewtopic&p=4116540#... Reply to the post : http://www.jboss.com/index.html?module=bb&op=posting&mode=reply&a...