Maciej Swiderski [
http://community.jboss.org/people/swiderski.maciej] replied to the
discussion
"jBPM 4.3 starting a sub-process after a state node will fail"
To view the discussion, visit:
http://community.jboss.org/message/535344#535344
--------------------------------------------------------------
hi,
I did run your use case and it worked. Only thing is that I created Subprocess since it
was not included in the zip file.
1. WfeUtility -deploy SubZzA.jpdl.xml (this should return deployment id to have a
reference in case of need for clean up)
2. WfeUtility -deploy SubProcTasks.jpdl.xml (this should return deployment id to have a
reference in case of need for clean up)
3. WfeUtility -start SimSubProc - this should return process instance id
------ so now we have process started and it is in check_id node
4. WfeUtility -signal PROC_INST_ID returned by step 3 - this should return process
instance id after signal
--------- now we are in sub process state1 - here is my simple sub process with just one
state within it
5. WfeUtility -signal SUBPROCESS_INST_ID - had to look it up in db
---- now we left sub process and went to state ok
WfeUtility -signal PROC_INS_ID returned by step 4
----- process is finished
Attached is complete set of files of process definitions
Cheers,
Maciej
--------------------------------------------------------------
Reply to this message by going to Community
[
http://community.jboss.org/message/535344#535344]
Start a new discussion in jBPM at Community
[
http://community.jboss.org/choose-container!input.jspa?contentType=1&...]