[infinispan-dev] L1 Consistency with Sync Caches

First off I apologize for the length. There have been a few Jiras recently that have identified L1 consistency issues with both TX and non TX sync caches. Async caches with L1 have their own issues as well, but I only wanted to talk about sync caches. https://issues.jboss.org/browse/ISPN-3197 https://issues.jboss.org/browse/ISPN-2965 https://issues.jboss.org/browse/ISPN-2990 I have proposed a solution in https://github.com/infinispan/infinispan/pull/1922 which should start L1 consistency down the right track. There are quite a few comments on it if you want to look into it more, but because of that I am moving this to the dev mailing list. The key changes in the PR are the following (non-tx): 1. Concurrent reads for a key that can retrieve a remote value are "corralled" into a single thread of execution for that given key. This would reduce network traffic with concurrent gets for the same key. Note the "corralling" only happens on a per key basis. 2. The single thread that is doing the remote get would update the L1 if able (without locking) and make available the value to all the requests waiting on the get. 3. Invalidations that are received would first check to see if there is a current remote get occurring for it's keys. If there is it will attempt to cancel the L1 write(s) before it occurs. If it cannot cancel the L1 write, then it must also wait on the current remote get completion and subsequently run the invalidation. Note the cancellation would fail when the remote get was done and it is in the middle of updating the L1, so this would be very small window. 4. Local writes will also do the same thing as the invalidation with cancelling or waiting. Note that non tx local writes only do L1 invalidations and don't write the value to the data container. Reasons why I found at https://issues.jboss.org/browse/ISPN-3214 5. Writes that require the previous value and don't have it in the L1 would also do it's get operations using the same "corralling" method. 4/5 are not currently implemented in PR. This approach would use no locking for non tx caches for all L1 operations. The synchronization point would be done through the "corralling" method and invalidations/writes communicating to it. Transactional caches would do almost the same thing as non-tx. Note these changes are not done in any way yet. 1. Gets would now update the L1 immediately after retrieving the value without locking, but still using the "corralling" technique that non-tx does. Previously the L1 update from a get was transactional. This actually would remedy issue [1] 2. Writes currently acquire the remote lock when committing, which is why tx caches are able to update the L1 with the value. Writes would do the same cancellation/wait method as non-tx. 3. Writes that require the previous value and don't have it in the L1 would also do it's get operations using the same method. 4. For tx cache [2] would also have to be done. [1] - https://issues.jboss.org/browse/ISPN-2965?focusedCommentId=12779780&p... [2] - https://issues.jboss.org/browse/ISPN-1540 Also rehashing is another issue, but we should be able to acquire the state transfer lock before updating the L1 on a get, just like when an entry is committed to the data container. Any comments/concerns would be appreciated. Thanks, - Will