[jboss-user] [JBoss Messaging] - MDB to RemoteQueue configuration problems

JBM.1.4.0.SP3 / jboss-4.2.2.GA I'm using the wiki at http://wiki.jboss.org/wiki/HowDoIConfigureAnEJB3MDBToTalkToARemoteQueue. I have found the following problems: 1. No way to use discovery for the remote jms provider I'm trying to setup it via | ... | <attribute name="Properties"> | java.naming.factory.initial=org.jnp.interfaces.NamingContextFactory | java.naming.factory.url.pkgs=org.jnp.interfaces | | jnp.partitionName=XYZ | => does not work 2. Using fixed addreses | ... | <attribute name="Properties"> | java.naming.factory.initial=org.jnp.interfaces.NamingContextFactory | java.naming.factory.url.pkgs=org.jnp.interfaces | | java.naming.provider.url=hostA:1200 | ... | This one works. But there is some strange problem. If I shutdown the remote cluster and then start it back again some of my MDBs are reconnected to hostA:1200, but some to other cluster nodes in my LAN that are not part of the same partition name? 3. Using combination of fixed addresses and discovery config | ... | <attribute name="Properties"> | java.naming.factory.initial=org.jnp.interfaces.NamingContextFactory | java.naming.factory.url.pkgs=org.jnp.interfaces | | jnp.partitionName=XYZ | java.naming.provider.url=hostA:1200 | => this works as expected - all MDBs are reconnected to hostA So, I have two questions: Q1: Is there a way to configura a remote JMS provider with discovery? Q2: Is cluster partitioning via partionName-s enough or I have to setup different multicast addresses for each partition? View the original post : http://www.jboss.com/index.html?module=bb&op=viewtopic&p=4176508#... Reply to the post : http://www.jboss.com/index.html?module=bb&op=posting&mode=reply&a...