Multiplexer doesn't work without FLUSH -------------------------------------- Key: JGRP-406 URL: http://jira.jboss.com/jira/browse/JGRP-406 Project: JGroups Issue Type: Bug Affects Versions: 2.4 Reporter: Bela Ban Assigned To: Vladimir Blagojevic Fix For: 2.5 To reproduce: - comment (in stacks.xml) FLUSH in the "udp" section - Run (e.g.) DrawMultiplexer 2282 [ERROR] JChannelFactory.connect(): - failed sending SERVICE_UP message java.lang.IllegalStateException: Flush is not supported, add pbcast.FLUSH protocol to your configuration at org.jgroups.JChannel.startFlush(JChannel.java:1765) at org.jgroups.JChannel.startFlush(JChannel.java:1823) at org.jgroups.JChannelFactory.connect(JChannelFactory.java:366) at org.jgroups.mux.MuxChannel.connect(MuxChannel.java:126) at org.jgroups.demos.DrawMultiplexer.start(DrawMultiplexer.java:40) at org.jgroups.demos.DrawMultiplexer.main(DrawMultiplexer.java:29) Exception in thread "main" java.lang.IllegalStateException: Flush is not supported, add pbcast.FLUSH protocol to your configuration at org.jgroups.JChannel.stopFlush(JChannel.java:1828) at org.jgroups.JChannelFactory.connect(JChannelFactory.java:377) at org.jgroups.mux.MuxChannel.connect(MuxChannel.java:126) at org.jgroups.demos.DrawMultiplexer.start(DrawMultiplexer.java:40) at org.jgroups.demos.DrawMultiplexer.main(DrawMultiplexer.java:29) Disconnected from the target VM, address: '127.0.0.1:2841', transport: 'socket' Process finished with exit code 1 -- This message is automatically generated by JIRA. - If you think it was sent incorrectly contact one of the administrators: http://jira.jboss.com/jira/secure/Administrators.jspa - For more information on JIRA, see: http://www.atlassian.com/software/jira