[ https://issues.jboss.org/browse/JBTM-1925?page=com.atlassian.jira.plugin.... ] Tom Jenkinson edited comment on JBTM-1925 at 9/25/13 10:31 AM: --------------------------------------------------------------- This now works, however port 8787 is blocked by the firewall on the CI nodes. Therefore, you will need to use port forwarding to access the debug port. Once you have port forwarding setup, it's just a matter of pointing your debugger at localhost:8787. You can setup port forwarding by running the following command: {code} ssh -L 8787:localhost:8787 hudson@<CI_NODE_NAME> {code} Alternatively, you can add the following to your ~/.ssh/config file for each CI node: {code} Host <CI_NODE_NAME> User <CI_USERNAME> LocalForward 8787 localhost:8787 {code} Then you just need to do this to setup the port forwarding. {code} ssh <CI_NODE_NAME> {code} was (Author: paul.robinson): This now works, however port 8787 is blocked by the firewall on the CI nodes. Therefore, you will need to use port forwarding to access the debug port. Once you have port forwarding setup, it's just a matter of pointing your debugger at localhost:8787. You can setup port forwarding by running the following command: {code} ssh -L 8787:localhost:8787 hudson@<CI_NODE_NAME> {code} Alternatively, you can add the following to your ~/.ssh/config file for each CI node: {code} Host <CI_NODE_NAME> User hudson LocalForward 8787 localhost:8787 {code} Then you just need to do this to setup the port forwarding. {code} ssh <CI_NODE_NAME> {code} -- This message is automatically generated by JIRA. If you think it was sent incorrectly, please contact your JIRA administrators For more information on JIRA, see: http://www.atlassian.com/software/jira